(10) Crosby G450 Wire Rope Clip, U-Bolt, U-Clip, 1 1/4" Dia Cable Rigging Clamp

Description

Each bid is for a Full Case of 10 brand new clips Part #1010275.  Retail approximately each!!!  I have another listing on Ebay where I am selling these individually if you don't need a full case of 10.  Please be aware that the ruler measurements in the pictures are approximate as the angle of the camera may slightly alter the exact length.  I am also listing other Crosby rigging items such as A-350L Sliding Choker Hooks, 8 1/2 Ton Screw Pin Anchor Shackles and GR-80 Grab Hooks. Check my 100% positive feedback with over 20 years on Ebay and bid with confidence!!!
Product Description
The best-known wire rope clip in the industry
Each base has a Product Identification Code (PIC) for material traceability, the name CROSBY or CG, and its size forged into it
Achieves 90% efficiency of published wire rope breaking strength
Entire clip is galvanized to resist corrosion
Each is clip is bagged or tagged with proper identification information
Satisfies ASME B30.26 requirements
Meets Federal Specification FF-C-450 Type I, Class 1
Proper use of Wire Rope Clips
Refer to the illustration below in following these instructions. Turn back specified amount of rope from thimble or loop. Apply first clip on base width from dead end of rope. Apply U-bolt over dead end of wire rope – live end rests in saddle. Tighten nuts evenly, alternate from one nut to the other until reaching the recommended torque.
When two clips are required, apply the second clip as near the thimble or loop as possible. Tighten nuts evenly, alternating until reaching the recommended torque. When more than two clips are required, apply the second clip as near the loop or thimble as possible, turn nuts on second clip firmly, but do not tighten. Proceed to Step 3.
When three or more clips are required, space additional clips equally between the first two – take up rope slack – tighten nuts on each U-bolt evenly, alternating from one nut to the other until reaching the recommended torque.
Apply initial load equal to loads expected in use. Inspect for proper orientation and spacing of clips and retighten the nuts to recommended torque.
Specifications
MPN
1010275
Model
G-450
Wire Rope Size
1-1/4"
Type
Forged
Overall Width
4.13"
Thread
0.88"
Clips Req'd Per End
7
Box / Case Quantity
10
Weight (lbs)
4.38